Your posttion:
Home » News » How to Shovel Snow on Roads with Solar Road Studs Installed?

How to Shovel Snow on Roads with Solar Road Studs Installed?

2024-11-20
0 views times
Winter has arrived in the northern hemisphere, and many areas have begun to snow. For municipal departments, winter snow removal is a very important project. Timely snow removal is conducive to restoring normal traffic and travel safety early. Now many roads are equipped with safety infrastructure such as solar road studs. Solar powered road studs provide directional guidance for drivers on rainy days, foggy days, and periods of low visibility by actively emitting light and flashing reminders, effectively improving road safety. However, when winter snowfall comes, these solar road studs’ surfaces must also be cleared in time to ensure smooth traffic and driving safety. How about we clear snow on these roads with solar road studs installed?
solar road stud for lighting

1. Choose suitable snow removal equipment.

When clearing snow on the road surface where solar road studs are installed, try to choose flexible snow shoveling equipment and use snow shovels with rubber or plastic blades to minimize the impact on the road surface and solar powered road studs. At the same time, ensure that the snow shoveling device is kept at a certain distance from the ground so that it is 1-2 cm higher than the surface of the road studs, which can not only remove the main snow but also avoid scratching the road studs.

2. Choose other snow removal methods

* Spread snow-melting agent. Use environmentally friendly snow-melting agents such as calcium chloride and potassium acetate to dissolve snow and avoid mechanical snow shoveling to damage solar powered road reflectors. When using snow-melting agents, prevent excessive use from corroding ssolar powered road studs.
* Use steam or low-temperature hot water to clear snow. This method is suitable for clearing snow in small areas or special sections of roads, such as the entrances and exits of tunnels. However, avoid using hot water at too high a temperature to avoid damage to the electronic components inside the solar road studs.
* Use snow-blowing equipment. If the snowfall is small, a small snow blower or high-pressure air gun lamp can be used to remove relatively light snow. This snow removal method will not touch the solar led road studs and will not cause damage.
solar powered road reflectors
solar powered road reflectors

3. Inspection and maintenance after snow removal

* Clean up residues: Clean up residual snow-melting agents and debris in time to avoid corrosion of the solar road stud shell or reduce the efficiency of solar panels.
* Check damage: Regularly check whether the solar road studs are damaged by snow shoveling and replace or repair them in time if necessary.

4. Choose the right road stud.

* Choose a solar road stud with strong pressure resistance. In areas with heavy snowfall, choose solar powered road reflectors with high pressure resistance during installation to cope with the pressure of snowplows and other vehicles.
* Reasonable layout of solar led road studs. In areas with frequent snow accumulation, try to install solar road studs in the middle or edge of the road to reduce direct contact with snowplows.
* Choose embedded installation. When installing solar powered road reflectors, the top of the road studs is flush with the road surface or slightly lower than the road surface, which provides great convenience for the smooth passage of snowplows.
solar road stud for sale
The installation of solar led road studs on the road does not mean that snow cannot be removed normally. As long as we choose the right snowplow equipment and take appropriate protective measures for the solar road studs during the snowplowing process, it will not affect the normal snowplowing. Whether it is timely clearing snow or installing solar road studs, it is to ensure traffic safety, and the two are not contradictory. If you have any questions about the snowplowing project of solar road studs in winter, you can contact us, and we will provide you with reasonable suggestions.
+86-13602600950



Inquiry
If you have any question or comment, please contact us without hesitation. We will reply you as soon as possible.( * is required information)
*Name:
*Email:
Phone:
Company:
Country:
*Message:


Hot Products
NOKIN Amber Raised Solar Road Stud Light For Expressway NK-RS-A6-1
NOKIN Amber Raised Solar Road Stud Light For Expressway NK-RS-A6-1
2020-05-18

Body material: Aluminum(GB-ADC12)+PC(Japan Brand)
Power supply: USA Brand High Efficient Solar Panel
Battery: NI-MH1.2V/600MAH; Lithium battery3.2V/500MAH(Made in Japan);
Resistance: >30T
LED Color: White, Yellow, Blue, Red, Green
Size: L125mm*W107mm*H26+50mm

Heavy Duty Solar Road Stud For Sale NK-RS-X5
Heavy Duty Solar Road Stud For Sale NK-RS-X5
2020-05-18

Body material: Casting Aluminium alloy +PC
Power supply: 5V/80MAH Mono crystalline silicon
Battery: Lithium battery3.2V/1000MAH
Resistance: >40T(can be installed in the middle of road)
LED Color: White, Yellow, Blue, Red, Green
Size: φ125*50mm

Round PC Solar Road Stud Light NK-RS-K1
Round PC Solar Road Stud Light NK-RS-K1
2020-05-18

Body material: PC
Power supply: Solar panel(Monocrystalline 2.5V /0.2W)
Battery: NIMH 600MAH
Resistance: >20T(static)
LED Color: White, Yellow, Blue, Red, Green
Size: φ117*23mm

Ultra Thin PC Solar Road Stud Light For Road NK-RS-Q7
Ultra Thin PC Solar Road Stud Light For Road NK-RS-Q7
2020-05-18

Body material: PC
Power supply: High efficient solar panel(5V/60mA)
Battery: Lithium battery(3.2V/500mAh)
Resistance: 15T
LED Color: White, Yellow, Blue, Red, Green
Size: 114*90*11mm

Nokin Solar Road Stud For Sale NK-RS-D1
Nokin Solar Road Stud For Sale NK-RS-D1
2020-05-18

Body material: Hi-pressure Casting Aluminium alloy
Power supply: Solar panel(monocrystalline 2.5V/0.2W)
Battery: NI-MH 1.2V/800MAH or lithium battery
Resistance: >20T(static)
LED Color: White, Yellow, Blue, Red, Green
Size: L104*W104*H20mm

Yellow Flashing Aluminum Raised Solar Cat Eyes Road Stud On Road NK-RS-A6
Yellow Flashing Aluminum Raised Solar Cat Eyes Road Stud On Road NK-RS-A6
2020-05-18

Body material: Hi-pressure Casting Aluminium alloy
Power supply: Solar panel(Monocrystalline 2.5V /0.2W)
Battery: NI-MH1.2V/800MAH
Resistance: >20 Tons
LED Color: White, Yellow, Blue, Red, Green
Size: L123*W133*H22mm+55mm

Internally Illuminated Solar Pavement Levelled Markers Studs NK-RS-X6
Internally Illuminated Solar Pavement Levelled Markers Studs NK-RS-X6
2020-05-18

Body material: Aluminum Alloy+PC cover
Power supply: Solar panel(Monocrystalline 2.5V /120MA)
Battery: Lithium battery 1000MAH*3.2V
Resistance: >30 Tons
LED Color: White, Yellow, Blue, Red, Green
Size: Ф123*45mm

6 LED Embedded Solar Road Marker Light Supplier In China NK-RS-A10
6 LED Embedded Solar Road Marker Light Supplier In China NK-RS-A10
2020-05-18

Body material: Cast Aluminum
Power supply: Solar panel(Monocrystalline 2.5V /0.2W)
Battery: NI-MH 1.2V/800MAH
Resistance: >30 Tons
LED Color: White, Yellow, Blue, Red, Green
Size: Ф120*50mm(bottom)
Ф135*50mm(upper)

Colorful Aluminum Solar Road Stud Light For Road NK-RS-A6-2
Colorful Aluminum Solar Road Stud Light For Road NK-RS-A6-2
2020-05-18

Body material: Heavy duty casting aluminium
Power supply: Solar panel(monocrystalline 2.5V/0.2W)
Battery: NI-MH 1.2V/800MAH
Resistance: >20T(static)
LED Color: White, Yellow, Blue, Red, Green
Size: L129*W114*H23mm+53mm

China Aluminuim Solar Road Stud Light For Sale With Best Price NK-RS-T1
China Aluminuim Solar Road Stud Light For Sale With Best Price NK-RS-T1
2020-05-18

Body material: Aluminum+PC
Power supply: Mono crystalline solar panel
Battery: NI-MH 1.2V/ 600mah(high temperature resistance);
Resistance: >20T(static)
LED Color: White, Yellow, Blue, Red, Green
Size: 125*43*30mm

Colorful Glass Solar Road Stud Cheap Price in China NK-RS-A7
Colorful Glass Solar Road Stud Cheap Price in China NK-RS-A7
2020-05-18

Body material: Tempered Glass/PC
Power supply: USA Brand High Efficient Solar Panel
Solar panel(Monocrystalline 2.5V /0.2W)
Battery: NI-MH1.2V/600MAH(high temperature resistance, made in China)
Lithum battery3.2V/500MAH(made in Japan)
Resistance: >20T
LED Color: White, Yellow, Blue, Red, Green
Size: φ112*56mm

Aluminium Solar Powered Road Studs For Sale NK-RS-A1
Aluminium Solar Powered Road Studs For Sale NK-RS-A1
2020-05-15

Body material: Hi-pressure Casting Aluminium alloy
Power supply: Solar panel(monocrystalline 2.5V/0.2W)
Battery: NI-MH 1.2V/800MAH
Resistance: >20T(static)
LED Color: White, Yellow, Blue, Red, Green
Size: L104mm*W94mm*H20mm

    nokin solar road stud factory WhatsApp